27 piece gang mold to make rubber washers to the DIN125A size M6 like you could use to buy at the store in any quantity in the early 2000s.
You MUST use Stoner
...Show more mold release on the molds above 55 degrees Fahrenheit.
1) Spray thoroughly/coat and leave for 5 mins.
2) Spray and then brush with an acid brush to distribute. Leave for 5mins.
3) Spray and then brush with an acid brush to distribute. Leave for 5mins.
4) Bring inside to your 70-80F deg workstation and prepare your resin for pouring. Coloring optional.
5) Leave in mold 3-5hrs (Alumilite). Carefully remove with a pick set. Let sit flat for 16-24hrs. You can move them after this to finish curing. It is about 72 hours.
